Skip to content

We ship worldwide from Lithuania.

Poire Noire

Journal

How Our Skateboard Wall Mount Has Evolved

Poire Noire team · November 2, 2026 · 4 min read

Back of a maple skateboard deck with its black 3D-printed bracket, beside the two wedge mount pieces slotted together

By the Poire Noire team

Short answer: We went through about three earlier mount designs before landing on the current one. Older designs could break in transit and damage the board's printed vinyl, so we redesigned the mount as a 3D-printed wedge that ships more easily and protects the board. Every board now arrives with its bracket already fixed on, and you simply hook it onto a small 3D-printed wall plate on your wall. The mount is tested to hold 15 kg+ when mounted properly with fixings suited to your wall.

How we got here

Our mount went through about three earlier designs. One of them was a three-piece system: a wall mount, a bracket fixed to the board and a hook that snapped the two together.

The problem showed up in shipping. Older designs could break in transit, and a broken mount could damage the printed vinyl on the board. We didn't want any board arriving marked, so we redesigned it.

The final design: a wedge mount

The result is our final design: a wedge mount we 3D print ourselves, in-house. The parts slide and wedge together, the mount is compact, it ships more easily and it protects the board in transit.

Fingers sliding the black 3D-printed wedge piece into its matching mount plate, halfway in

Black 3D-printed wedge piece pushed fully into its mount plate, held between fingers

How the new mount works

  • Board bracket: black, 3D printed in-house, already fixed to the top centre of the back of the deck with a permanent adhesive pad. Ready to hang straight away.
  • Wall plate: a small 3D-printed wall plate the bracket wedges into, fixed to the wall with two screws.

Back of a maple skateboard deck with a black 3D-printed mount bracket fixed near the top, next to the two separate black wedge mount pieces

Screw the wall plate to the wall, then slide the bracket down into the wall plate. The board hangs from one central point, so a small nudge levels it.

Back of a maple skateboard deck with its black 3D-printed bracket, beside the two wedge mount pieces slotted together

Screws and wall plugs are not included, because every wall is different. Choose fixings that suit your wall.

What's better for you

  • Arrives safely. The wedge design ships more easily and protects your board's print.
  • Ready to hang. The bracket is already fixed to the board.
  • Strong. The mount is tested to hold 15 kg+ when mounted properly with fixings suited to your wall.
  • Easy to level. One central hanging point.
  • Spares available. Need a replacement or extra mount? Email [email protected].

FAQ

What is the new Poire Noire wall mount? A bracket we 3D print in-house, permanently fixed to the back of each board, that wedges onto a small 3D-printed wall plate screwed to the wall.

Why did you change the mount? Older designs could break in shipping and damage the board's vinyl. The new wedge design ships more easily and protects the board.

How much weight does it hold? The mount is tested to hold 15 kg+ when mounted properly with fixings suited to your wall.

Are screws and plugs included? No. Choose fixings that suit your wall.

Can I remove the bracket? No. The adhesive is permanent.

Can I get a replacement mount? Yes, email [email protected].

Where's the full install guide? See our step-by-step hanging guide.